User Tools

Site Tools


tuning

This is an old revision of the document!


Tuning notes

these engines will never run better using pod air filters, unless you have a deep understanding of jetting and a test rig.

Air

Reinstate the airbox.

Replace the stock airfilter - if neccesary replace the old paper part with some air filter foam.

Fuel

Clean the carb.

filter the petrol

jet correctly

balance the carbs

flow

set the valves to the manual recomendations - but tend towards the bigger gap size. on a cold engine.

valve gaps:

inlet gap (0.14 to) 0.19mm

exhaust gap ((0.21 to) 0.26mm

Spark

check that the wiring is good and well connected - clean the bullet connectors.

check that coil is offering resistance.

set points gap manually to begin with - again go wide.

points gap (0.3 to) 0.4mm

now check timing - best done with a strobe at low revs (check higher revs too to see that advance/retard mech is performing)

Then reset points gap with a dwell meter.

chances are dwell will have you opening points gap wider than the advised gap.

remember this is an old bike with a worn engine - it will perform better with slightly advanced ignition timing at tickover, and with a generous amount of slack on the valves.

spark plug get new ones, they are cheap and worth it.

again set to widest (if you have set dwell to the longest range and cleaned your contacts the spark will be long bright and strong enough to cope, and the fuel air mixture wont stand a chance).

spark plug gap (0.6 to) 0.7mm

Fuel

a lot of problems are caused by the recent(ish) addition of ethanol to petrol - and most people blame the mechanics of the bike on them. Ethanol is hydroscopic - it attracts water, the dew that forms inside your tank every morning. Ethanol in petrol absorbs the water and does a thing called phase separation - this is when it effectively turns into vaseline (petroleum jelly) and sinks to the bottom of the tank, and the carbs.

It is this gunge that causes any bike that has been standing for a few days to misbehave, with symptoms of blocked jets that could be misconstrued as weak spark or any other classic starting issue.

There are two solutions - 1 keep your bike in a warm low humidity environment, like your living room, or 2 use a petrol stabiliser, wurth and redex both make good products. Simply using a synthetic lead replacement additive is not enough, make sure that the product says that it deals with ethanol.

actually there is a third option, get to your nearest airfield and fill up with 100LL - it is the same leaded petrol without ethanol that these engines were designed to run on.

tuning.1478112379.txt.gz · Last modified: 2016/11/02 18:46 by dp